Integral (non separable) vertical bearing pedestal with screw tight bearing housing cover. Vertical bearing block assemblies were originally developed as axle boxes for light track trucks, but can also be used for traditional vertical bearing block assemblies. The non separable vertical bearing pedestal assembly has higher rigidity than the separable bearing pedestal, and some can accept heavier loads. The primary characteristics are simple structure and low cost; The gap formed due to wear cannot be adjusted; It can only be installed or removed axially.

The primary feature of the split type bearing block (commonly known as the tile box) is its convenient disassembly and the ability to adjust the empty space formed by wear, but its structure is more complex and precise than that of the full type bearing block. It should also be thoroughly cleaned and inspected. Scrape away the dirt from the inner cavity of the bearing block with a scraper, and guide the bearing block device forward. Clean the dirt with a cloth dipped in gasoline or solvent, and observe for cracks and sand holes in order to prevent oil leakage during operation. The joint surface between the bearing cover and the bearing seat, as well as the contact surface between the bearing seat and the bearing oil retaining ring, should be subject to grinding and scraping coordination, and checked with a feeler gauge. The gap should not be greater than 0.03 mm. The bottom plate on which the bearing seat is placed should also be kept clean and free of bumps, rust, and burrs. He should carefully inspect the screws and seat plate threads that fasten the bearing block, and try to tighten the screws to see if they are too tight or bare.

1、 The most common cause of bearing seat heating in bearing adapter manufacturers is the improper amount and type of grease involved, resulting in such an environment that I need to clean the bearing seat. If necessary, it is necessary to replace new grease

2、 Due to the excessive vibration of the equipment, the bearings may also experience a heating environment.

3、 There are many objective conditions that can also cause the bearing pedestal to heat up, such as too high external ambient temperature, or due to the high rotational speed of the fan, or possibly due to the formation of equipment.