How to clean and inspect the split bearing seat?

Before the introduction of the split bearing pedestal device, all cleaning and inspection should also be carried out. Scrape off the dirt in the inner cavity of the bearing seat with a scraper, wipe off the dirt with a cloth dipped in gasoline or solvent, and observe for cracks and sand holes to prevent oil leakage during operation. The joint surface between the bearing cover and the bearing seat, as well as the joint surface between the bearing seat and the bearing oil retaining ring, should be scraped and matched, and checked with a feeler gauge. The clearance should not be greater than 0.03 mm. The surface of the bottom plate of the placed bearing pedestal should also be cleaned and free of bumps, rust, and burrs. The screw and seat plate threads of the fastening bearing pedestal should be carefully inspected and tried to tighten the screw to see if it is too tight or bald.

Sectional bearing seat, with separable upper cover and base, mainly bearing radial loads, suitable for self-aligning roller bearings and self-aligning ball bearings with cylindrical and tapered holes.

The bearing seat is mainly used in metallurgy, mining, transportation systems, environmental protection equipment, etc. The main models include SN series, SD series, SNU series, SNL series, 1500 series, 1600 series, Z2500Y series, Z2600Y series, GZ2 series, and GZ4 series. The main difference between each series is the different loads and sealing forms (wool felt, double lip seal, U-shaped seal, labyrinth seal, etc.). It has good thermal conductivity, installation and disassembly performance. Convenient unloading and greatly improved sealing effectiveness. The sliding bearing seat is composed of an upper cover, a base, a separating bearing bush (aluminum bronze), and mounting bolts, mainly bearing radial loads. Easy to use, no need to install bearings. The non load bearing part of the inner surface of the bearing pad has oil grooves, and the lubricating oil flows into the gap through the oil inlet hole and the mail groove. It is mainly used in industrial fields such as metallurgy and conveying equipment. The main models are H20000, H400, HX00, HZ000, ZHC2-00, XHC4-00. The self-aligning bearing with a tight set is fixed to the shoulderless shaft, and the structural bearing is convenient. It consists of a weighing sleeve, a nut, and a gasket. The models include H series, HE series, HS series, HA series, and OH series.