Only a thorough dissection of the split bearing pedestal can reveal damage points

Only a thorough dissection of the split bearing pedestal can reveal the damage point! Although split bearing pedestals can be used in different industries, in various cases, split bearing pedestals can be damaged, and damage can be found. However, it is not known where the damage is located. A thorough dissection can identify the point of damage.

When disassembling the split bearing block, the outer ring is connected to the upper carriage, the inner ring is connected to the lower carriage, the sealing ring of the split bearing block is cleaned, the well crane separates the equipment, and the screws and bolts of the split bearing block are removed. Remove all steel balls and isolation sleeves, and inspect the steel balls and isolation sleeves. If the isolation sleeve has cracks or damage, it should be replaced in a timely manner. Check whether the steel ball is clean and exposed to sunlight. You can clearly see whether there are pits or pits on the steel ball.

What should be paid attention to when installing and removing split bearing blocks? Any mechanical equipment requires routine maintenance, and split bearing pedestals are no exception. What should I pay attention to during installation and removal? The following is a detailed introduction to this issue by the technical personnel of the Shuihongsheng bearing manufacturer!

During installation, do not directly hammer the end face and non stressed surface of the split bearing seat. Use a press block, sleeve, or other installation tools to evenly stress the split bearing seat. Do not install with the transmission power of a rolling body. Applying lubricating oil to the mounting surface will make the installation smooth. If there is excess fit, please heat the split bearing pedestal in mineral oil to 80~90 ℃ and install it as soon as possible. Strictly control the oil temperature to not exceed 100 ℃ to prevent the tempering effect from reducing hardness and affecting dimensional recovery. When it is difficult to disassemble, it is recommended to use a disassembly tool to pull outward, while paying attention to the hot oil towards the inner ring. The heat expands the inner ring of the separated bearing pedestal, which is easy to fall off.